| |
 | This puzzle was build form a normal 3x3x3 Rubik's cube as kernel, it is a prototype. |
 
| I used the 3x3x3 axle and cut down the top and bottom part, the extensions on the axle
are the old centre's and I cut them in two halves. Two 1mm x 20mm steel needle pins are
used to support the extensions on the axle. |
| The corners of this 3x3x2 is a 3x3x3 corner, I just removed and clued the corner
extension. One side is flattened. |
| The edge is a 3x3x3 edge, with a grove in the middle that turns on the axle. |
|
